Fabrication Defect

1 case · 1 image

Crevice Corrosion in a Subsea System — Aspect Before Analysis

Standard: D2 Capture method: Surface Aspect clear all

Fabrication Defect — sub-branches

Heat Treatment Defect 1

Results

SortNewestOldestTitle A-ZTitle Z-A
Detailed aspect of the cracks in the internal diameter surface, where the hardness level was too low. These are typical overloading cracks.
76
VIEW
ML00131 / Apr.2018
Brittle Failure of a Soft Roller Bearing
M - Wear Resistant SteelP - Roller BearingAp - Mechanical IndustryCd - Heat Treatment Defect
Cm - Surface AspectDf - Cracks